Install The Usb Driver For The Pc Connection Cable; Update The Firmware Of The Transceiver - Yaesu WIRES-X FT3D Instruction Manual

Install the USB driver for the PC connection cable

This procedure is not necessary if the USB driver of the SCU-19*
used.
*1(The SCU-19 is included in the SCU-39 kit.)
*2(The SCU-20 is included in the SCU-40 kit. FTM-400XD/D and FTM-100D include the SCU-20.)
1. Download the SCU-19 USB driver for FT3D/FT2D or the SCU-20 USB driver for FTM-400XD/D, FTM-300D and
FTM-100D from YAESU website (http://www.yaesu.com/).
2. Unzip the downloaded file and copy all the files to the desired folder.
3. Refer to the "Driver Installation Manual" PDF file in the folder and install the USB driver on the PC.

Update the firmware of the transceiver

This procedure is not necessary if the firmware of the transceiver used for the Portable Digital Node station is the latest
version already posted on YAESU website.
1. To check the firmware version of the transceiver, use the following procedure:
 FT3DR/DE or FT2DR/DE
(1) Press and hold the [DISP] key to display "SETUP MENU", then touch [DISPLAY].
(2) Rotate the DIAL knob, then touch [9 SOFTWARE VERSION] (FT3D) or [11 SOFTWARE VERSION] (FT2D).
The firmware version of "Main" and "Sub", "DSP" will be displayed.
 FTM-100DR/DE
(1) Press and hold the [DISP(SETUP)] key to display "SETUP MENU".
(2) Rotate the DIAL knob to select "13 RST/CLONE".
(3) Press the [DISP](SETUP) key.
(4) Rotate the DIAL knob to select "8 SOFTWARE VERSION", then press the [DISP](SETUP) key.
The firmware version of "MAIN CPU" and "PANEL CPU", "DSP CPU" will be displayed.
 FTM-300DR/DE
(1) Press and hold the [F(SETUP)] key to display "SETUP MENU".
(2) Rotate the DIAL knob to select "DISPLAY".
(3) Press the [F(SETUP)] key.
(4) Rotate the DIAL knob to select "5 SOFTWARE VERSION", then press the [DISP(SETUP)] key.
The firmware version of "Main" and "Sub", "DSP" will be displayed.
 FTM-400XDR/DE or FTM-400DR/DE
(1) Press and hold the [DISP](SETUP) key to display "SETUP MENU".
(2) Touch [RESET/CLONE].
The firmware version of "MAIN" will be displayed on the top of the screen.
(3) Touch [BACK].
(4) Touch [TX/RX].
(5) Touch [DIGITAL].
(6) Rotate the DIAL knob to select [5 DSP VERSION].
The "DSP" firmware version will be displayed to the right of [5 DSP VERSION].
For details on checking the firmware version of the transceiver other than the above, refer to the owner's manual of each
transceiver.
or the SCU-20*
1
11
is already installed on the PC to be
2