Disconnecting From The Node Or Room; Closing The Wires-X Software; Operating The Transceiver In Portable Hri Mode; Ft3D/Ft2D - Yaesu WIRES-X FT3D Instruction Manual

⿟ Confirming the location of the other station
When latitude and longitude data is included in the signal of the other station, the distance and direction of the other
station may be displayed in real time on the transceiver screen.

FT3D/FT2D:

Press the [DISP] key to display the compass screen. Press the [DISP] key again to return to the
normal screen.
FTM-400XD/D: Press the [DISP] (SETUP) key to display the compass screen. Press the [DISP] (SETUP) key twice
to return to the normal screen.
FTM-300D: Press the [DISP] key on the connection screen to display the compass screen. Press the [DISP] key
again to return to the normal screen.
FTM-100D:
The callsign of the other station, and the direction and distance are displayed alternately at the top
of the screen automatically.
On the "BACKTRACK" screen (compass screen), operation may not be switched between "Access Point" or "Direct
Operation" by pressing the [A/B] key.

Disconnecting from the node or room

To disconnect a node or room on the Internet, from the "Connection" menu of WIRES-X software, click "Disconnect".

Closing the WIRES-X software

1. From the "File" menu, select "Exit"
If "Enable WIRES-X Auto Start." has been selected when
installing the WIRES-X software, the software will restart
immediately after closing the software.
If you do not want to restart the software, click the
WIRES-X icon on the right part of the Windows task bar (or
from the hidden indicator list), then select "Quit" or "Auto
Start" to remove the check mark.

Operating the transceiver in Portable HRI Mode

You can change settings such as transceiver screen display in use and turn OFF the TX/BUSY Lamp in Portable HRI Mode.
FT3D/FT2D
Function
Switching between Access Point and Direct Operation
BACKTRACK screen (compass screen)
Transmission sound monitor function on or off
SQL open
SQL level setting
Switching TX/RX LED on or off
Dimmer setting
Lamp setting
Change of the busy detection (noise squelch / DG-ID
number match)
Key
Press the A/B key
Press the DISP key (Direct Operation only)
Press the V/M key (Direct Operation only)
Press the MONI key
FT3D: Press the SQL key, then rotate the VOL knob
FT2D: Press the SQL key, then rotate the DIAL knob
Press and hold the V/M key
Press the BAND key
Press and hold DISP key
Press and hold the A/B key
49