Installing The Sfp Transceiver - Planet Networking & Communication IGS-6329 Series User Manual

2.3.1 Installing the SFP Transceiver

The sections describe how to insert an SFP/SFP+ transceiver into an SFP/SFP+ slot. The SFP/SFP+ transceivers are
hot-pluggable and hot-swappable. You can plug in and out the transceiver to/from any SFP/SFP+ port without having to power
down the Industrial Managed Switch as
Follow all the SFP installation steps as shown in the example.

Approved PLANET SFP/SFP+ Transceivers
PLANET Industrial Managed Switch supports both single mode and multi-mode SFP transceivers. The following list of
approved PLANET SFP/SFP+ transceivers is correct at the time of publication:
Fast Ethernet Transceiver (100BASE-X SFP)
Model Speed (Mbps) Connector Interface
MFB-FX 100
MFB-F20 100
MFB-F40 100
MFB-F60 100
MFB-TFX 100
MFB-TF20 100
Figure 2-3-1 appears.
Figure 2-3-1: Plug in the SFP/SFP+ Transceiver
Fiber Mode
LC Multi Mode
LC Single Mode
LC Single Mode
LC Single Mode
LC Multi Mode
LC Single Mode
45
Distance Wavelength (nm)
2km 1310nm
20km 1310nm
40km 1310nm
60km 1310nm
2km 1310nm
20km 1310nm
Operating Temp.
0 ~ 60 degrees C
0 ~ 60 degrees C
0 ~ 60 degrees C
0 ~ 60 degrees C
-40 ~ 75 degrees C
-40 ~ 75 degrees C