Mvrp Global Configuration - Planet Networking & Communication IGS-6329 Series User Manual

4.3.9.2 MVRP Global Configuration

This page allows you to configure the MVRP global and per port settings altogether. The page is divided into a global section
and a per-port configuration section.
The displayed settings are:
Object
• Global State
• Managed VLANs
MVRP Port Configuration
• Port
• Enabled
• Default
Description
Enable or disable the MVRP protocol globally. This will enable or disable the
protocol globally and at the same time on the switch ports that are MVRP
enabled.
This field shows the managed VLANs, i.e. the VLANs that MVRP will operate
upon. By default, only VLANs 1- 4094 are managed, i.e. the entire range as
defined in IEEE802.1Q-2014 for MVRP. However this range can be limited by
using a list syntax where the individual elements are separated by commas.
Ranges are specified with a dash separating the lower and upper bound.
The following example will create VLANs 1, 10, 11, 12, 13, 200, and
300: 1,10-13,200,300. Spaces are allowed in between the delimiters.
The port number for which the following configuration applies.
Enable or disable the MVRP protocol on this switch port. This will enable or
disable the protocol on the switch port given that MVRP is also globally enabled.
To set the switch port to use the default VL
165