Initial Installation; Installing The Tv Set; Set Covers; Connecting The Tv Set - Loewe Xelos 46 Operating Instructions Manual

Initial installation

Installing the TV set

Installation options
Your TV set is supplied equipped with a table stand. You are given the
option of choosing another installation solution tailored to your require-
ments from your Loewe dealer. Only use Loewe installation solutions (e.g.
wall mounts, floor stand) that are included in the Accessories – Setup
possibilities chapter on page 107.
After selecting an installation option, read the appropriate assembly
instructions.
Installation notes
Choose a place for installing your TV where no bright light or sunlight
shines directly onto the screen. This could cause reflections which impair
the picture.
3 times the screen diagonal can be taken as a guide value or the view-
ing distance (e.g. for 40-inch set approx. 3m for SD signal). The viewing
distance can be reduced with an HD signal.

Set covers

Covers for side connections
The side cover of the TV set can be completely removed. For this, open
it as far as it will go and gently pull on the open cover.
The cover detaches from the holder and gives free access to the con-
nection area. To replace the cover, simply push it until it latches back
into place.
- 18

Connecting the TV set

Connecting to the mains
Remove the cover for the connections.
Connect the TV set to a 220-240V mains socket:
First plug the small plug of the power cable into the mains connection on
the back of the TV and then plug the large mains plug into a mains socket.
Connecting antennas
Cable (analogue) / DVB-C / DVB-T antenna:
Plug the antenna cable of antenna, cable system or room antenna into
the ANT TV socket.
If you want to use analogue cables / DVB-C connection and a DVB-T
antenna together, use an external antenna switch (available from your
dealer).
Satellite antenna DVB-S:
Depending on the used satellite system, connect a connecting cable from
the multi-switch or directly from the LNC to the ANT-SAT socket of the TV.
When connecting the TV set to a single cable community antenna, con-
nect the ANT-SAT socket directly to the appropriate SAT antenna socket.
Ask your dealer if required.
Cable
analogue /
DVB-C DVB-T
R TV
DVB-S