Table of Contents
Advertisement
USER GUIDE
Cutout & Product Dimensions
PREPARE SITE
Your U‑Line product has been designed for free‑standing
installation. The free-standing units require specific
clearances to run most efficiently.
NOTE: Measurements in inches (mm).
CAUTION
!
Unit can NOT be installed behind a closed door.
CUTOUTS
This unit does not require cutout dimensions.
PRODUCT DIMENSIONS
Refer to Figure 1, Figure 2, and Figure 3, for the
dimensions of the unit.
Cutout & Product Dimensions
26-7/32" (666)
21-3/16"
(538)
198-27/32"
(504)
77-11/32"
(1964)
1/4"
(5)
71-1/4"
(1810)
6" (154)
24" (610)
Figure 1: Front View of Dimensions
CLEARANCES
Maintain the following clearances when installing this unit:
•
Make sure the unit is not installed near the following
sources of heat (and similar):
◦
Ovens
◦
Radiator
◦
In the path of direct sunlight
•
Allow for a space of at least 11‑13/16" (300 mm)
between the back of the unit and any wall. This
distance helps to avoid condensation forming
•
Make sure the motor is free of any obstacle
which could hinder or limit the circulation of the
condensing unit
•
Allow for a space of at least 19 ‑11/16" (500 mm)
between the top of the unit and the ceiling (see
Figure 4)
•
Make sure the environment allows for adequate
airflow to guarantee cooling for the condenser and the
compressor unit (see Figure 5)
10-13/32"
(264)
8-13/32"
(213)
27/32" (21)
6 1/4" (159)
3-1/4"
(83)
2 31/32"
8-5/32"
(75)
5 5/16 (135)
(207)
1-21/32"
(42)
1-27/32" (47)
3-3/4"
(95)
12
Advertisement
Table of Contents
