10
TUNING THE CHASSIS
10.9
Adjusting the handlebar position
–
Remove screws
one side.
Info
Cover the components to protect them against damage.
Do not kink the cables and lines.
–
Remove screws
–
Move the handlebar holder to the desired position. Mount and tighten the two
screws
601875-10
Guideline
Screw, handlebar support
Info
Position the handlebar holders evenly on the left and right.
–
Position the handlebar.
Info
Make sure the cables and wiring are positioned correctly.
–
Position the handlebar clamps. Mount screws
Guideline
Screw, handlebar clamp
. Take off the handlebar clamps. Remove the handlebar and lay it to
. Remove the handlebar support.
.
M10
Loctite
40 Nm
(29.5 lbf ft)
and tighten evenly.
M8
20 Nm
(14.8 lbf ft)
68
®
243™