Table of Contents
Advertisement
1-4
A1
Explanation of Signal Words and Symbols
MERCHANDISERS SHIPPED
Signal words and safety symbols that are used in a product's collateral materials or on the product may
be defined in collateral materials if space is available.
WITH END INSTALLED
A1.1
Safety Alert Symbol
The meaning of the safety alert symbol may be provided in collateral materials. The following artwork may
If the merchandiser was shipped with the end
be used for this purpose.
installed, two long bolts were used to hold the
shipping brace to the end . If the shipping bolts
are reinserted after removing the brace, they
will extend into the product area . T
sure To replace These bolTs wiTh The shorTer
. NSF requires any bolt or screw
bolTs provided
in the product area be capped or cut off if it
A1.2
Signal Words
has more than three exposed threads .
The meaning of the different signal words as defined by the ANSI Z535.6 and ANSI Z535.4 standards
may be explained in collateral materials. The following artwork may be used for this purpose.
Be careful not to damage the factory
installed end while moving the
merchandiser.
»
Do not remove shipping braces
until the merchandisers are
positioned for installation.
A1.3
Other Highlighting Conventions
The meaning of any other highlighting conventions used to differentiate safety messages (e.g., text
manipulations, indention, etc.) may be explained in collateral materials.
A1.4
Safety Symbols
The meaning of any safety symbols used on safety labels or collateral materials may be explained in
collateral materials.
P/N 0535974 _R
K
Safety Signs and Labels
(Informative)
This is the safety alert symbol. It is used to alert you
to potential physical injury hazards. Obey all safety
herefore
messages that follow this symbol to avoid possible
injury or death.
DANGER indicates a hazardous situation which, if not
avoided, will result in death or serious injury.
WARNING indicates a hazardous situation which, if not
avoided, could result in death or serious injury.
CAUTION indicates a hazardous situation which, if not
avoided, could result in minor or moderate injury.
NOTICE is used to address practices not related to
physical injury.
Safety instructions (or equivalent) signs indicate specific
safety-related instructions or procedures.
© 2017 National Electrical Manufacturers Association
Licensee=Hussmann Corp/8160899001, User=Trevett, Jason
Not for Resale, 02/16/2021 11:49:55 MST
Ultra Low
Front Cases
U.S. & Canada 1-800-922-1919 • Mexico 01-800-890-2900 • www.hussmann.com
END SHIPPING BRACES
Move the merchandiser as close as possible to
its permanent location, then remove all packaging .
Check for damage before discarding packaging .
Remove all separately packed accessories such
as kits and shelves .
,
be
Do not remove end braces until joining begins.
Recycle wooden braces and hardware .
SHIPPING RIDER
Some merchandisers are shipped on a rider to
protect the factory installed front legs, and to
make positioning the merchandiser easier . To
remove the rider, remove bolts attaching rider to
each leg .
Shipping Rider
Remove 6 Screws and
Wooden Supports Prior to
Moving Case into Position
(rear rail will remain
attached to merchandiser)
Shipping Braces
Advertisement
Table of Contents
