Hdmi/Usb Connector Board - HP ZBook x2 Manual

HDMI/USB connector board

Description
HDMI/USB port connector board (includes HDMI port, USB port, and cable)
Before removing the HDMI/USB port connector board, follow these steps:
1. Shut down the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on,
and then shut it down through the operating system.
2. Disconnect all external devices connected to the tablet.
3. Disconnect the power from the tablet by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the tablet.
4. Remove the display panel assembly (see
Remove the HDMI/USB port connector board:
1. Release the shielding material (1) that covers the HDMI/USB port connector board cable and connectors.
2. Release the ZIF connector (2) to which the HDMI/USB port connector board cable is connected, and then
disconnect the HDMI/USB port connector board cable from the system board.
3. Remove the two Phillips M2.0×3.0 screws (3) that secure the HDMI/USB port connector board to
the back cover.
4. Remove the HDMI/USB port connector board (4).
NOTE: When installing the HDMI/USB port connector board, make sure the printing on the HDMI/USB port
connector board cable is visible. If the printing is not visible, the HDMI/USB port connector board cable is installed
incorrectly.
Reverse this procedure to install the HDMI/USB port connector board.
44 Chapter 5 Removal and replacement procedures
Display panel assembly on page
Spare part number
L03248-001
30).