Table of Contents
Advertisement
5.4 OnCue Plus Generator Management System
®
The OnCue
Plus Generator Management System allows monitoring and control of your generator set from a personal computer,
smart phone, or tablet. OnCue Plus can also be configured to send email or text message notifications in the event of a generator
set fault. See the OnCue Plus Manuals for instructions.
OnCue Plus
OnCue Plus is provided with the generator set. Purchase and install the OnCue Plus Wireless kit, or use category 5E network
cable to connect the RDC2 controller to the customer-supplied Ethernet router or modem. Route the cable with other low-voltage
signal wiring (for example, the RBUS communication leads or engine start leads to the transfer switch), in separate conduit from
the AC load leads. If the network cable is longer than 100 meters (328 ft.), use a repeater or switch.
Recommended: Use a laptop computer to verify the network connection before connecting to the generator set.
Checking the network connection
1.
Check for and turn OFF any wireless connections to the laptop.
Connect the network cable to the laptop. Connect the other end of the network cable to the customer's router or modem.
2.
3.
Verify the Internet connection by opening your web browser and going to www.kohlerpower.com or any known website.
4.
After verifying the connection through the network cable, disconnect the network cable from the laptop and turn the
laptop wireless connections back on.
Connect to the Ethernet cable in the customer connection area of the generator set. See Figure 43. Use an RJ45 inline coupler,
provided with the OnCue Plus kit, to connect the customer's Ethernet cable to the cable in the customer connection box.
Ethernet cable for OnCue
Plus connection
Figure 43
Network Connection for OnCue Plus
TP-7091
4/23
GM84094
51
Hide quick links:
Advertisement
Table of Contents
