Oncue Plus Generator Management System; Load Management; Programmable Interface Module (Pim) - Kohler 24RCLA Operation

4.5 OnCue Plus Generator
Management System
The Kohler OnCue Plus Generator Management
System is now included with the generator set. The
OnCue Plus System allows monitoring and control of
your generator set from your home or other location with
Internet access using a computer or mobile device.
OnCue Plus can be configured to send email or text
message notifications in the event of a generator set
fault.
You can also use Google Assistant or Amazon Alexa
and your smart device to control your generator. Use
voice commands to check your generator's status,
check for active alerts, and start or stop an exercise.
See the OnCue Plus User Guide, TP- 7006, for simple
setup instructions and voice commands.
OnCue Plus Wireless is also available. OnCue Plus
Wireless works with the customer's wireless Ethernet
router and does not require the installation of a network
cable between the generator set and the customer's
router/modem.

4.6 Load Management

Two optional load management devices are available
for use with single-phase generator sets and a model
RXT or RDT transfer switch:
The optional Load Shed Kit mounts inside a model
D
RDT or RXT transfer switch.
The combined interface/ load management board is
D
available for the Model RXT transfer switch.
The load management devices provide an automatic
load management system to comply with Section 702.5
of NEC 2008.
Note: The load management devices are only
compatible with single-phase generator sets.
With a load management system, less critical
appliances can be powered by the generator set when
TP-6905 9/21
the more important appliances are not running, allowing
the use of a smaller generator set than would be needed
to run all of the building's electrical equipment at the
same time.
The load management device automatically manages
up to six residential loads.
Two relays are included to control two independent
D
heating, ventilation, and air conditioning (HVAC)
loads.
Up to four power relay modules can be connected
D
through normally open relay contacts on the circuit
board. Power relay modules are available separately.
The load management device receives commands from
the RDC2 generator controller and energizes or
de-energizes the appropriate load relays to add or shed
non-critical loads according to their priority.
Note: Connect only non-essential loads to the load
shed kit.
The load management device automatically manages
up to six residential loads. Two relays are provided to
control two independent air conditioner loads. Up to four
power relay modules
management of non- essential secondary loads.
4.7 Programmable Interface
Module (PIM)
The optional Programmable Interface Module (PIM)
provides two programmable
programmable dry contact outputs for connection to
customer- supplied equipment.
controlled by the RDC2 controller, and can also be
controlled remotely using OnCue Plus.
The PIM is mounted in a NEMA 3R aluminum enclosure,
which can be mounted indoors or outdoors. See the
installation instructions provided with the PIM for more
information.
can be connected
inputs and
The outputs
Section 4 Accessories
for
six
are
53