Filtration Modes For Spas With Circulation Pump Option (J-230, J-270 & J-280 Only) - Jacuzzi J-230 Owner's Manual

J-200 Series
perature display flashes when this function is enabled. Example: the "F3"
filtration/heating cycle was enabled prior to choosing lock mode. The spa
continues to perform the "F3" cycle until lock mode is canceled, allowing
another cycle to be selected.
To set a time for the first filtration/heating cycle, simply turn power on to the
spa two minutes prior to the desired time. Example: If you desire your first
filtration/heating cycle to begin at 10:00 AM turn off power to the spa and turn
it back on again at 9:58 AM. Note: start time is approximate and may vary
slightly from day to day.
11.7 Filtration Modes for Spas With Circulation Pump Option (J-230,
J-270 & J-280 Only)
If your spa is not equipped with the circulation pump option, disregard this section
and refer to page 25
Standard Filtration/Heating Modes (F0-F3)
(Heater automatically turns on during any heat call while in any Standard mode).
F0 5 minutes of filtration per day (one 5 minute "Blow-Out"
cycle every 24 hours to purge all plumbing lines)
F1 1 hour of filtration per day (one 30-minute cycle every
twelve hours); this is the factory default setting.
F2 1.5 hours of filtration per day (one 30-minute cycle every
eight hours).
F3 2 hours of filtration per day (one 30-minute cycle every six
hours).
Economy Filtration/Heating Modes (F4-F6)
(Heater can only turn on during an active filter cycle while in any economy
mode).
F4 1 hour of filtration/heating per day (one 30-minute cycle
every twelve hours).
F5 1.5 hours of filtration/heating per day (one 30-minute cycle
every eight hours).
F6 2 hours of filtration/heating per day (one 30-minute cycle
every six hours).
Lock Modes (L1-L2)
L1 Lock Out (disables all spa functions to permit filter
cleaning).
L2 Lock Mode (disables the jets and light buttons to prevent
unauthorized use of spa). Filtration/heating cycle will con-
tinue to operate as programmed in this mode. The tempera-
ture display flashes when this function is enable. Example:
the "F3" filtration/heating cycle was enabled prior to choosing lock mode.
26
for filter cycle programming details.