Adjusting The Projected Image - BenQ V7000i User Manual

Adjusting the projected image

Adjusting the projection angle
If the projector is not placed on a flat surface or the
screen and the projector are not perpendicular to
each other, the projected image becomes trapezoidal.
You can screw the adjuster feet to fine-tune the
horizontal angle.
To retract the feet, screw the adjuster feet in a
reverse direction.
Do not look into the lens while the light source is on. The strong light from the light source may cause damage to
your eyes.
Fine-tuning the image clarity
Go to INSTALLATION > Motor Focus and use
Correcting keystone
Keystoning refers to the situation where the projected image becomes a trapezoid due to angled
projection.
To automatically correct this, enable Auto Keystone in the INSTALLATION menu.
To manually correct this:
1. Press KEYSTONE on the remote control or go
to INSTALLATION > Keystone.
2. Press / on the remote control.
3. After the Keystone correction page appears, press
to correct keystoning at the top of the image. Press
to correct keystoning at the bottom of the image.
When done, press
16 Positioning your projector
BACK to save and exit.
/ to adjust the focus settings.
Press
.
Press
.