Table of Contents
Advertisement
Step 4:
Specify Keystone.
For more information about keystone, see
Correcting
keystone.
Step 5:
Specify Auto Source.
Select On if you want the projector to always
search for available signals automatically when the
projector is turned on.
Now you've completed the initial setup.
4. Switch all of the connected equipment on.
5. You can also press
page
24.
• Please use the original accessories (e.g. power cord) to avoid possible dangers such as electric shock and fire.
• If the projector is still hot from previous activity, it will run the cooling fan for approximately 90 seconds before
energizing the light source.
• The Setup Wizard screenshots are for reference only and may differ from the actual design.
• If the frequency/resolution of the input signal exceeds the projector's operating range, you will see the message
"Out of Range" displayed on the background screen. Please change to an input signal which is compatible with
the projector's resolution or set the input signal to a lower setting. See
• If no signal is detected for 3 minutes, the projector automatically enters saving mode.
QS01 Android TV setup
Before you start
Check that you have:
• A Wi-Fi Internet connection
• A Google Account
Step 1: Press and hold OK for 5 seconds to pair your remote control
SOURCE to select your desired input signal. See
Switching input signal on
Timing chart on page
47.
Operation
19
Advertisement
Table of Contents
