Table of Contents
Advertisement
Replacing the remote control batteries
1. Open the battery cover, as illustrated.
2. Remove the old batteries (if applicable) and install two
AAA batteries. Make sure that the positive and negative
ends are positioned correctly, as illustrated.
3. Refit the battery cover until it clicks into place.
4.
• Avoid leaving the remote control and batteries in an excessive heat or humid environment like the kitchen,
bathroom, sauna, sunroom or in a closed car.
• Replace only with the same or equivalent type recommended by the battery manufacturer.
• Dispose of the used batteries according to the manufacturer's instructions and local environment regulations for
your region.
• Never throw the batteries into a fire. There may be danger of an explosion.
• If the batteries are dead or if you will not be using the remote control for an extended period of time, remove the
batteries to avoid damage to the remote control from possible battery leakage.
Using the positioning units
Two rulers can be pulled out from the rear of the projector to measure the projection distance
between the projector and the screen, which helps you in positioning the projector.
Introduction
9
Advertisement
Table of Contents
