Table of Contents
Advertisement
3. The four arrow keys ( ,
represent 4 digits (1, 2, 3, 4). According to the password
you desire to set, press the arrow keys to enter six digits
for the password.
4. Confirm the new password by re-entering the new
password.
Once the password is set, the OSD menu returns to the
PASSWORD page.
5. To activate the Power On Lock function, press
/
to select On. Input the password again.
• The digits being input will be displayed as asterisks on-screen. Make a note of your selected password and keep it
in a safe place in advance or right after the password is entered so that it is available to you should you ever
forget it.
• Once a password has been set and the power on lock is activated, the projector cannot be used unless the
correct password is entered every time the projector is started.
If you forget the password
If you enter the wrong password, the password error
message will appear, and the INPUT CURRENT
PASSWORD message follows. If you absolutely do not
remember the password, you can use the password recall
procedure. See
Entering the password recall procedure on
page
23.
If you enter an incorrect password 5 times in succession, the
projector will automatically shut down in a short time.
Entering the password recall procedure
1. Press and hold OK for 3 seconds. The projector will
display a coded number on the screen.
2. Write down the number and turn off your projector.
3. Seek help from the local BenQ service center to decode
the number. You may be required to provide proof of
purchase documentation to verify that you are an
authorized user of the projector.
Changing the password
1. Go to SYSTEM SETUP: ADVANCED > Password > Change Password.
2. Press OK. The INPUT CURRENT PASSWORD message appears.
3. Enter the old password.
• If the password is correct, another message INPUT NEW PASSWORD appears.
• If the password is incorrect, the password error message will appear, and the message INPUT
CURRENT PASSWORD appears for your retry. You can press
change or try another password.
4. Enter a new password.
5. Confirm the new password by re-entering the new password.
,
,
) respectively
INPUT NEW PASSWORD
/
to highlight Power On Lock and press
RECALL PASSWORD
Back
Password Error
Please try again.
Please write down the recall code,
and contact BenQ
Customer Center.
Recall Code:
255
255
255
255
Exit
BACK to cancel the
Operation
23
Advertisement
Table of Contents
