Troubleshooting; Caring For And Maintaining The Cam1000 / Bsc01 - Dometic BSC01 Installation And Operating Manual

Troubleshooting

9 Troubleshooting
Fault
The device shows no
function.
"NO SIGNAL" is
displayed on the
monitor.
A yellow GPS icon
appears on the monitor.
A red GPS icon appears
on the monitor.
Frequent wrong indica-
tion at the end of the
vehicle when driving
right in a curve.
Frequent false alarms on
uneven surfaces
10

Caring for and maintaining the CAM1000 / BSC01

A
NOTICE! Damage hazard
Do not use sharp or hard objects or cleaning agents for cleaning as these may damage
the product.
➤ Occasionally clean the product with a damp cloth.
12
Cause
The system plug is not con-
nected or not correctly plugged
into the control electronics.
No video signal present. Loose
contact in the plug connector of
the camera cable
The camera is defective.
GPS reception is faulty.
No object detection is available.
The camera points too far back.
Due to the 180° angle of view of
the camera, the image moves
from back to front and the system
also detects non-relevant
objects.
Vehicle parts, which move rela-
tive to the camera, are captured
as an object, e.g. box body
CAM1000 / BSC01
Solution
Check the system plug and make
sure that it locks into place.
Check that the connections are
secure.
Contact an authorized service
center to replace the camera.
The system is active but the
acoustic warning signal is off until
a better GPS reception is
obtained.
Check that the connections are
secure.
Align the camera as perpendicu-
lar as possible. The red test field
should stop at about 8 m from
the front of the vehicle.
Find the corresponding vehicle
parts (e.g. front edge of the box
body) and take them out of the
active area by readjusting the
camera. Use the reference lines
as a tool for this purpose (see
also fig. c).
EN