Using The Cam1000 / Bsc01 - Dometic BSC01 Installation And Operating Manual

Using the CAM1000 / BSC01

• If you do need to lay a cable outside the vehicle, ensure that it is well fastened (use additional
cable ties, insulating tape etc.).
• To prevent damage to the cables when laying them, ensure that they are always far enough
away from hot or moving vehicle components (exhaust pipes, drive shafts, light systems, fans,
heaters, etc.).
• Attach the cables securely in the vehicles to prevent tripping hazards. This can be performed by
using cable binders, insulating tape or gluing in place with adhesives.
• Protect every through-hole made in the bodywork against water penetration by suitable mea-
sures, e.g. by using a cable with a sealant and by spraying the cable and the cable sleeve with
sealant.
I
NOTE
• In Germany and Austria, special requirements apply for the operation to fulfill the
operating license.
• CAM1000 / BSC01 may only be operated with the M75LXAHD monitor.
This version of CAM1000/ BSC01 is equipped with a customized connector. There is no need to
connect single wires as long as the MAN interfacing connector is pre-equipped.
8 Using the CAM1000 / BSC01
I
NOTE
On the initial start-up the GPS receiver must save the satellite position. This may take up
to 5 minutes.
8.1 Detection range
The detection range of the CAM1000 / BSC01 is divided into two zones:
• Visible area: depending on mounting height in operating mode A or B
• Active area: about 8 m x 4 m
I
NOTE
The view of the camera into the detection area must not be obscured by vehicle parts.
Objects may not be detected.
10
CAM1000 / BSC01
EN