Connecting To Weld Output Terminals; Adjusting Shoulder Strap - Hobart Stickmate 160i Owner's Manual

5-4. Connecting To Weld Output Terminals

5-5. Adjusting Shoulder Strap

OM-278400 Page 16
.
A complete Parts List is available at www.HobartWelders.com
1
3
2
1
! Turn off power before connecting
to weld output terminals.
! Do not use worn, damaged, un-
dersized, or repaired cables.
1 Negative (−) Weld Output Terminal
2 Positive (+) Weld Output Terminal
3 Dinse Weld Connector
Insert Dinse connector fully into termi-
nal. Rotate connector clockwise to lock
in position.
2
Connect dinse 2017−03 − 279282-A / 802554
1 Shoulder Strap
2 Adjuster
Use adjuster to change strap length as
desired. Be sure strap is routed through
adjuster as shown.
279982-A / 279438-A