Connecting To Weld Output Terminals; Installing Work Clamp; Setting Gun Polarity For Wire Type - Hobart H200L4-15 Owner's Manual

.
A complete Parts List is available on-line at www.HobartWelders.com

5-3. Connecting To Weld Output Terminals

Tools Needed:
3/4 in. (19 mm)
!
Turn off power before connecting to
weld output terminals.
!
Failure to properly connect weld
cables may cause excessive heat
and start a fire, or damage your
machine.

5-4. Installing Work Clamp

Tools Needed:
1/2, 3/4 in.

5-5. Setting Gun Polarity For Wire Type

Tools Needed:
3/4 in.
Wire Drive Assembly Lead
+
Positive Terminal
−
Negative Terminal
OM-235 281 Page 14
1
2
4
Do not place
anything between
weld cable terminal
and copper bar.
Correct Installation
1 Weld Output Terminal
2 Supplied Weld Output Terminal Nut
3 Weld Cable Terminal
4 Copper Bar
Remove supplied nut from weld output ter-
minal. Slide weld cable terminal onto weld
1
2
Changing Polarity
Work Clamp Lead
3
Incorrect Installation
output terminal and secure with nut so that
weld cable terminal is tight against copper
bar. Do not place anything between weld
cable terminal and copper bar. Make
sure that the surfaces of the weld cable
terminal and copper bar are clean.
1 Work Cable
Route cable out front panel opening
from inside.
2 Negative (−/Black) Output
3
Terminal
Connect cable to terminal.
3 Hardware
4 Work Clamp
Route cable through clamp handle
and secure as shown.
4
Close door.
Shown as shipped - Electrode Positive (DCEP):
For solid steel, stainless steel, aluminum, or flux
core with gas wires (GMAW).
Electrode Negative (DCEN):
Reverse lead connections at terminals from that
shown above for gasless flux core wires (FCAW).
Drive assembly becomes negative.
803 778-A
Ref. 242 145-B
Ref. 242 145-A