Weld Output Terminals; Connecting Weld Output Cables - Hobart Champion 145 Owner's Manual

5-5. Weld Output Terminals

Tools Needed:
3/4 in

5-6. Connecting Weld Output Cables

1
Tools Needed:
3/4 in. (19 mm)
!
Turn off power before connecting to
weld output terminals.
!
Failure to properly connect weld
cables may cause excessive heat
and start a fire, or damage your ma-
chine.
.
Do not place anything between weld
OM-250 200 Page 20
.
Complete Parts List available at www.HobartWelders.com
1
6
3
4
5
cable terminal and copper bar. Make
sure that the surfaces of the weld cable
terminal and copper bar are clean.
1 Correct Weld Cable Connection
2 Incorrect weld Cable Connection
3 Weld Output Terminal
4 Supplied Weld Output Terminal Nut
1
2
For Direct Current Electrode Posit-
ive (DCEP), connect electrode
holder to Positive (+) terminal and
work cable to Negative (−) terminal.
For Direct Current Electrode Neg-
ative (DCEN), reverse cable con-
nections.
2
2
5 Weld Cable Terminal
6 Copper Bar
Remove supplied nut from weld output ter-
minal. Slide weld cable terminal onto weld
output terminal and secure with nut so that
weld cable terminal is tight against copper
bar.
Negative (−) Weld Output
Terminal
Positive (+) Weld Output
Terminal
251 051
803 778-B