Layer-2 Isolation Profile Commands; Layer-2 Isolation Profile Example - ZyXEL Communications nwa series Reference Manual

Chapter 8 Wireless LAN Profiles

8.6 Layer-2 Isolation Profile Commands

The following table identifies the values required for many of these commands. Other input values
are discussed with the corresponding commands.
Table 29 Input Values for General Layer-2 Isolation Profile Commands
LABEL
l2isolation_profile_nam
e
mac_address
description
The following table describes the commands available for Layer-2 Isolation profile managment. You
must use the
these commands.
Table 30 Command Summary: Layer-2 Isolation Profile
COMMAND
show wlan-l2isolation-profile {all | rule_count
| [l2isolation_profile_name]}
wlan-l2isolation-profile rename
l2isolation_profile_name1
l2isolation_profile_name2
[no] wlan-l2isolation-profile
l2isolation_profile_name
[no] mac_address
description description
exit

8.6.1 Layer-2 Isolation Profile Example

The following example creates a layer-2 isolation profile with the name 'test1'.
Router(config)# wlan-l2isolation-profile test1
Router(config-wlan-l2isolation test1)# 00:a0:c5:01:23:45
Router(config-wlan-l2isolation test1)# description user1
Router(config-wlan-l2isolation test1)# exit
Router(config)#
62
DESCRIPTION
The layer-2 isolation profile name. You may use 1-31 alphanumeric characters,
underscores (
value is case-sensitive.
The MAC address of the device that is allowed to communicate with the NWA/
WAC's wireless clients. Enter 6 hexadecimal pairs separated by colons. You can
use 0-9, a-z and A-Z.
Sets the description name of MAC address in the profile. You may use 1-60
alphanumeric characters, underscores (
configure terminal
), or dashes (-), but the first character cannot be a number. This
_
command to enter the configuration mode before you can use
DESCRIPTION
Displays the layer-2 isolation profile(s) settings.
all: Displays settings of all layer-2 isolation profiles configured
on the NWA/WAC.
rule_count: Displays how many layer-2 isolation profiles are
created on the NWA/WAC.
l2isolation_profile_name: Displays settings of the specified
profile.
Gives the existing layer-2 isolation profile
(l2isolation_profile_name1) a new name,
(l2isolation_profile_name2).
Enters configuration mode for the specified layer-2 isolation
profile. Use the no parameter to remove the specified profile.
Sets the MAC address of the device that is allowed to
communicate with the NWA/WAC's wireless clients in this profile.
Sets the description name for the MAC address associated with
this profile.
Exits configuration mode for this profile.
), or dashes (-).
_
NWA/WAC Series CLI Reference Guide