Zyxel Device Models With Multiple Leds; Nwa1123-Ac Pro - ZyXEL Communications NWA Seres User Manual

Table 12 NWA110AX, WAX510D and WAX650S LED (continued)
COLOR
Amber
Bright Blue
White
Blue
Red

3.3 Zyxel Device Models With Multiple LEDs

The LEDs of some Zyxel Device models can be controlled by using the suppression feature such that the
LEDs stay lit (ON) or OFF after the Zyxel Device is ready. Some Zyxel Device models also has Locator LED
which allows you to see the actual location of the Zyxel Device among several devices in the network.
See Section 1.4 on page 19
218 for the LED Suppression and Locator menus in standalone mode.
The following models have multiple LEDs: NWA1123-AC PRO, NWA1302-AC, WAC6103D-I, WAC5302D-S,
WAC6502D-E, WAC6502D-S, WAC6503D-S.

3.3.1 NWA1123-AC PRO

The following are the LED descriptions for your NWA1123-AC PRO.
Chapter 3 Hardware
STATUS
Steady On
Steady On
Steady On
Slow Blinking (On for
100ms per second)
Slow Blinking (Blink for 1
time, Off for 1 second)
On
Fast Blinking (On for 50
milliseconds, Off for 50
milliseconds)
Slow Blinking (Blink for 3
times, Off for 3 seconds)
to check which models support these features. Refer to
NWA/WAC/WAX Series User's Guide
42
DESCRIPTION
The Zyxel Device is ready for use, the Zyxel Device's wireless
interface is activated, and/or wireless clients are connected
to the Zyxel Device in limited power mode (see
page 67).
The Zyxel Device's wireless interface is activated, but there
are no wireless clients connected when it is in full power mode
(see Table 26 on page 67).
The Zyxel Device's wireless interface is activated, but there
are no wireless clients connected when it is in limited power
mode (see Table 26 on page
Locator LED is on. It switches off automatically after the
configured amount of time (1-60 min). Default duration is 10
minutes.
The Zyxel Device is performing a Channel Availability Check
(CAC) with Dynamic Frequency Selection (DFS) to monitor a
channel for radar signals.
The Zyxel Device failed to boot up or is experiencing system
failure.
The Zyxel Device is undergoing firmware upgrade.
The Uplink port of the Zyxel Device in standalone mode is
disconnected.
Table 26 on
67).
Chapter 21 on page