Drive Idler Assembly Replacement; Remove Attachment Drive Idler Assembly - Ariens Sno-Thro Platinum Series Service Manual

Measure
1
1. Belt Finger
2. Attachment Drive Belts
7. Adjust traction drive clutch. Refer to Operator's
Manual for adjustment procedure.
8. Reconnect spark plug wire.
IMPORTANT: Check all adjustments after first use.
Here
Figure 31
DRIVE IDLER ASSEMBLY
REPLACEMENT

Remove Attachment Drive Idler Assembly

IMPORTANT: Save all hardware for reinstallation.
1. Stop engine, remove key and wait for all moving parts
to stop and for hot parts to cool.
2. Disconnect spark plug wire from engine.
3. Remove auger housing. See Separate Housing From
Frame on page 7.
4. Remove attachment brake spring from frame. See
Figure 33.
2
See Figure 34.
5. Remove torsion spring from attachment idler arm.
6. Remove tapping screws retaining attachment idler
arm to hub and remove idler assembly.
EN – 18
Figure 32
Figure 33