Hex Shaft Bearing Replacement; Remove Bearing; Install Bearing - Ariens Sno-Thro Platinum Series Service Manual

11. Adjust speed selector lever. Refer to Operator's
Manual for adjustment procedure.
IMPORTANT: Check all adjustments after first use.

HEX SHAFT BEARING REPLACEMENT

Remove Bearing

IMPORTANT: Save all hardware for reinstallation.
1. Stop engine, remove key and wait for all moving parts
to stop and for hot parts to cool.
2. Disconnect spark plug wire from engine.
See Figure 52.
3. Remove hardware retaining bearing flange to frame
and remove flange.
4. Remove bearing from hex shaft.

Install Bearing

1. Install bearing onto hex shaft end.
2. Install bearing flange over bearing and secure to
frame with three tapping screws.
EN – 24
Figure 51