Ariens Sno-Thro Platinum Series Service Manual page 11

See Figure 7.
13. Remove hairpin, sleeve bushing and cable eyelet from
deflector arm under dash panel.
14. With a pliers, compress cable anchor tabs and remove
anchor from deflector bracket.
IMPORTANT: Reinstall sleeve bushing and hairpin so parts
are not misplaced.
3
1
1. Cable Anchor
2. Deflector Arm
3. Deflector Bracket
15. Remove chute deflector cable from J-clamp on engine
mount. See Figure 8.
See Figure 9.
16. Remove tapping screw securing left side of belt cover
to frame.
17. Loosen, but DO NOT remove tapping screw securing
right side of belt cover to frame and remove belt cover.
2
Figure 6
Figure 7
18. Remove hardware retaining belt finger to engine and
remove belt finger. See Figure 10.
WARNING: AVOID INJURY. Attachment sheave
edges are sharp. Wear thick gloves to remove
belts from attachment sheave.
See Figure 11.
19. Remove attachment drive belts from attachment
sheave.
EN – 9
Figure 8
Figure 9