Install Left Bearing - Ariens Sno-Thro Platinum Series Service Manual

Install Left Bearing

IMPORTANT: Bearing plates are ONLY installed with
bearing on frame. Bearing plates are NOT installed with
bearing on side plate.
1. Secure each bearing to frame and / or side plate with
three hex bolts and three locking nuts.
2. Reinstall sleeve bushing between bearings on side
plate and frame.
3. Reinstall stepped-down end of long axle through side
plate, frame and into differential gear. See Figure 170.
4. Reinstall E-ring onto axle end. See Figure 171.
5. Tighten hardware securing axle mount plates to track
carriage.
6. Secure bottom cover to frame with six hex bolts.
7. Reinstall track drive wheels. See Install Track Drive
Wheel on page 63.
8. Reinstall tracks. See Install Track on page 64.
9. Return unit to operating position.
10. Reconnect spark plug wire and fill fuel tank.
11. Model 921052: Adjust track tension. Refer to
Operator's Manual for adjustment procedure.
Figure 168
Figure 169
IMPORTANT: RapidTrak model Model 921057 does not
require track tension adjustments.
IMPORTANT: Check all adjustments after first use.
EN – 65