Install Chute Rotation Gear - Ariens Sno-Thro Platinum Series Service Manual

6. Remove hardware retaining chute rotation gear to
pedestal plate and remove gear. See Figure 121.

Install Chute Rotation Gear

IMPORTANT: Discharge chute MUST be positioned
forward.
See Figure 123.
1. Position actuation gear with gear teeth at the lowest
position.
2. Install chute rotation gear and position so midpoint of
gear teeth are seated in lock arm.
IMPORTANT: Ensure markers on actuation gear and chute
rotation gear align.
Figure 120
3
1. Actuation Gear
2. Chute Rotation Gear
3. Lock Arm
3. Secure chute rotation gear to chute pedestal with
original hex bolt, flange bushing and flange nut. See
Figure 124.
4. Position chute rotation lever upright and discharge
chute facing forward.
5. Reinstall hex rod into actuation gear and secure with
original hairpin.
EN – 48
1
2
Figure 121
Figure 122