Ariens Sno-Thro Platinum Series Service Manual page 10

IMPORTANT: Discharge chute control designs differ based
on serial number. Generation 2 chute control designs
appear as shown in Figure 4 and Generation 3 chute
control designs appear as shown in Figure 5. Continue to
step 7 for service to units with Generation 2 designs and
advance to step 11 for service to units with Generation 3
designs.
Generation 2 Chute Control Designs
See Figure 4.
6. Remove hairpin and cable eyelet from chute control
assembly.
7. With a pliers, compress cable anchor tabs and remove
anchor from chute control assembly.
8. Guide cable end through hole in dash panel.
IMPORTANT: Reinstall hairpin into clevis pin so it is not
misplaced.
Generation 2 Chute Control Design
9. Advance to step 16.
Figure 4
Generation 3 Chute Control Designs
See Figure 5.
10. Remove hairpin from clevis pin and partially remove
clevis pin from chute control assembly.
11. With a pliers, compress cable anchor tabs and remove
anchor from chute control assembly.
12. Guide cable end through hole in dash panel.
IMPORTANT: Reinstall hairpin into clevis pin so it is not
misplaced.
Generation 3 Chute Control Design
1. Cable Anchor
2. Clevis Pin
EN – 8
1
Figure 5
2