Ce Conformity (Europe) - Honeywell UDC2800 Product Manual

Chapter 2 - Introduction

CE Conformity (Europe)

26
Bluetooth communications
The Bluetooth connection provides a non-intrusive wireless
connection with the instrument and maintains NEMA4X and IP66
integrity.
No need to get access to the back of the controller to communicate
with the instrument, no need to take your screwdriver to wire the
communication cable, no wiring mistake possible. You can now
duplicate an instrument's configuration, upload or download a new
configuration in a matter of seconds, just by connecting your mobile
device to instrument through Bluetooth.
: It takes less than 2 seconds to upload configuration
Connect & Upload
from an instrument. You can then save the configuration file onto
your mobile device for review, modification or archiving.
Furthermore, the software and app also give you important
maintenance information on the controller: instantly, get information
on the current operating parameters, digital inputs and alarm status,
identify internal or analog input problems.
: What if I have several controllers on the same panel? How
Questions
can I be sure I am communicating with the correct one?
: The Bluetooth is normally "off". You activate the Bluetooth on
Answer
a particular controller by pressing any key. Once activated, you can
pair with the controller. If a controller has been connected, the
Bluetooth status mark will show on the screen. Each controller may
also be assigned a different Bluetooth ID.
NOTE: The UDC device's Bluetooth ID appears in the
communications group on the controller screen.
This product is in conformity with Radio Equipment Directive
2014/53/EU. Conformity of this product with any other "CE Mark"
Directive(s) shall not be assumed.
Product Classification: Class I: Permanently connected, panel-
mounted Industrial Control Equipment with protective earthing
(grounding) (EN61010-1).
: This controller must be panel-mounted with the rear
Enclosure Rating
terminals enclosed within the panel. The front panel of the controller
is rated at NEMA4X and IP66 when properly installed.