Honeywell UDC2800 Product Manual page 123

Chapter 4 - Configuration
Function
Prompt
Input 2 Type
Input 2
Transmitter
123
Selections or
Range of Parameter Definition
Setting
TC Differential Thermocouple Differential
Slidewire 100-1K ohm Slidewire (For Position Proportional
Applications)
TC B
Transmitter Characterization
instruct the controller to characterize a linear input
TC E High
to represent a non-linear one. If characterization is
performed by the transmitter itself, then select
TC E Low
Linear.
TC J High
TC J Mid
TC J Low
TC K High
FOR EXAMPLE:
TC K Mid
If input 2 is a 4 to 20 mA signal, but the signal
represents a type K H thermocouple, then configure
TC K Low
K TC H and the controller will characterize the 4 to
TC M High 20 mA signal so that it is treated as a type K
thermocouple input (high range).
TC M Low
Parameter definitions are the same as in Input 2
TC N High
Type.
TC N Low
TC R
TC S
TC T High
TC T Low
TC W High
TC W Low
TC PR40-
PR20
RTD Pt100
ATTENTION: Prompt only appears when a
linear actuation is selected at prompt Input 2
Type.
—This selection lets you