Options Set Up Group - Honeywell UDC2800 Product Manual

Options Set Up Group

Introduction
The Options group lets you configure the remote mode switch
(Digital Inputs) to a specific contact closure response, or configure
the Auxiliary Output to be a specific selection with desired scaling.
Function Prompts
Table 4-13: Options Group Function Prompts
Function Prompt
Auxiliary Output
Selections or Range
of Setting
Disable
Input 2
Chapter 4 - Configuration
Parameter Definition
ATTENTION: Prompts for the
Auxiliary Output selection
appear only if one of the
Auxiliary Output boards is
installed.
This selection provides an mA output
representing one of several control
parameters. The display for auxiliary
output viewing will be in engineering
units for all but output. Output will
be displayed in percent.
ATTENTION: Other prompts
affected by these selections:
4mA VAL and 20mA VAL.
ATTENTION: Output cannot be
configured when Three
Position Step Control is used.
No Auxiliary Output
Input 2 represents the value of the
configured range of input 2.
138