Honeywell UDC2800 Product Manual page 75

Chapter 4 - Configuration
Function
Prompt
Run/Hold
Key
SP Select
Key
Restore
Settings
Restore*
Change
Password
75
Selections or
Range of Parameter Definition
Setting
Allows you to disable the Run/Hold key, for either SP
Ramp or SP Program. The Run/Hold key is never
disabled when used to acknowledge a latched alarm
1.
Disable Disable the Run/Hold Key
Enable Enable the Run/Hold Key
Reset Reset the latched alarm using the Run/Hold key
combination after the alarm condition is complete.
Setpoint Select Key Lockout allows you to disable the
Setpoint Select function
Disable Disable the Setpoint Select function
Enable Enable the Setpoint Select function
Allows you to reset the controller
Disable Disable
Enable Enable
It allows you to reset the controller to factory settings
while preserving configuration.
Disable Disable
Enable Enable
0 to 9999 Allows you to change the password.
ATTENTION: Can only be viewed if
configured for .
None
ATTENTION: Can only be viewed if
configured for .
None
ATTENTION: The device will restart if enabled.
NOTE: The password is for keyboard entry only
is
Lockout
is
Lockout