Umc800 Controller; Ce Conformity (Europe) - Honeywell UMC800 Installation And User Manual

Introduction

UMC800 Controller

UMC800 Controller
The UMC800 is industrial process control equipment that must be mounted. The wiring terminals must be
enclosed within a panel.

CE Conformity (Europe)

This product is in conformity with the protection requirements of the following European Council
Directives: 73/23/EEC, the Low Voltage Directive, and 89/336/EEC, the EMC Directive. Conformity of
this product with any other "CE Mark" Directive(s) shall not be assumed.
Deviation from the installation conditions specified in this manual, and the following special conditions,
may invalidate this product's conformity with the Low Voltage and EMC Directives.
ATTENTION
The emission limits of EN 50081-2 are designed to provide reasonable protection against
harmful interference when this equipment is operated in an industrial environment. Operation
of this equipment in a residential area may cause harmful interference. This equipment
generates, uses, and can radiate radio frequency energy and may cause interference to radio
and television reception when the equipment is used closer than 30 meters (98 feet) to the
antenna(e). In special cases, when highly susceptible apparatus is used in close proximity, the
user may have to employ additional mitigating measures to further reduce the electromagnetic
emissions of this equipment.
2 UMC800 Controller Installation and User Guide Release F
4/01