Config; Beep; Band Skip; Rpt Ars - Yaesu FTM-500DR Advance Manual

23 BEEP

Adjust the volume of the beep that sounds when a key is pressed.
1. Press and hold the FUNC knob  [23 BEEP]  Press the FUNC knob
2. Rotate the FUNC knob to select the desired setting.
The Beep volume can be selected from 3 levels.
OFF / LOW / HIGH

24 BAND SKIP

Set the band selected when the [BAND
1. Press and hold the FUNC knob  [22 BAND SKIP]  Press the FUNC knob
2. Rotate the FUNC knob to selct the band to be set with a Press the FUNC knob.
3. Rotate the FUNC knob to set "ON" (selectable) or "OFF" (not selectable).
OFF / ON
AIR:
OFF / ON
VHF:
OFF / ON
UHF:
OTHER: OFF / ON

25 RPT ARS

Set the auto repeater shift function.
1. Press and hold the FUNC knob  [25 RPT ARS]  Press the FUNC knob
2. Rotate the FUNC knob to select the desired setting.
AUTO The auto repeater shift function is enabled.
OFF The auto repeater shift function is disabled.
NOTE: This item is registered in the custom function menu by factory setting.

26 RPT SHIFT

Set the direction of the repeater transmit shift setting.
1. Press and hold the FUNC knob  [26 RPT SHIFT]  Press the FUNC knob
2. Rotate the FUNC knob to select the shift direction setting.
OFF (AUTO) The transmit frequency will not shift.
-
+

27 RPT SHIFT FREQ

Set the repeater transmit shift offset frequency.
1. Press and hold the FUNC knob  [27 RPT SHIFT FREQ]  Press the FUNC knob
2. Rotate the FUNC knob to select the desired repeater transmit shift offset frequency.
The offset can be set at 0.05 MHz intervals between 0.00 MHz and 99.95 MHz.
The default setting differs depending on frequency.

CONFIG

(108MHz - 137MHz)
(137MHz - 174MHz)
(400MHz - 480MHz)
(174MHz - 400MHz, 480MHz - 999.995MHz)
The transmit frequency will shift down.
The transmit frequency will shift up.
] key is pressed.
M V
►
52