Copying The Radio Data To Another Transceiver - Yaesu FTM-500DR Advance Manual

Copying the Radio Data to another Transceiver

The memory channels and settings in the set-up menu can be copied to another
FTM-500DR/DE. This is convenient when matching the settings of fellow stations that you
communicate with frequently.
1. Turn both transceivers OFF.
2. Connect the clone cable "CT-166" to the DATA jack on the back of the main bodies.
3. Turn both transceivers ON.
4. On the transceiver from which data is to be copied, press and hold the FUNC knob,
rotate the FUNC knob to select [119 This  Other], then press the FUNC knob.
The confirmation screen appears.
5. On the transceiver to which data is to be copied, press and hold the FUNC knob,
rotate the FUNC knob to select [120 Other  This], then press the FUNC knob.
The confirmation screen appears.
6. On the transceiver to which data is to be copied, rotate the FUNC knob to select [OK],
then press the FUNC knob.
7. On the transceiver from which data is to be copied, rotate the FUNC knob to select
[OK], then press the FUNC knob.
The data transfer begins.
8. Turn both transceivers OFF, then disconnect the clone cable.
• When "ERROR" appears on the screen during the clone operation, the operation has not
completed. Check the clone cable connection, and then repeat the procedure from the
beginning.
• If the clone operation is terminated due to a power loss during the data transfer, the
transceiver to which the data is copied will be reset automatically. Check the power supply,
cables and connections, then repeat the procedure again from the beginning.
30