Using The Voice Guide Unit Fvs-2; Mounting The Voice Guide Unit "Fvs-2 - Yaesu FTM-500DR Advance Manual

Using the Voice Guide unit FVS-2

The receive audio can be recorded and then played back later using the optional voice
guide unit "FVS-2". The frequency of the operating band can also be announced by voice
when the announce function is set to ON.

Mounting the voice guide unit "FVS-2"

z Preparations
• Voice guide unit "FVS-2" (optional)
• Phillips screwdriver
z Mounting procedure
• Avoid touching the electronic components with your hands as the semiconductors may be
damaged by static electricity.
• Note that labor charges to install optional items by our customer service support staff shall
be separately chargeable.
1. Turn the transceiver OFF.
2. Turn the external power supply OFF.
3. Unplug the control cable, microphone, and DC power supply cables from the main
chassis.
4. Remove the eight screws from the main body, four on
top and two each at the sides.
 : Please note that the 2 screws on the front panel side
of the top cover are longer than the other 6 screws.
5. Carefully lift the top cover of the main body.
Do not lift the top cover by force. This may result in
cables connected between the circuit boards and the
speaker inside the cover to be cut.
6. Unplug the speaker cables extending from the top cover from the socket on the board
inside the main body before removing the cover.
Hold the connector when unplugging the cable without pulling on the cable itself.
25

Speaker Cable
