Table of Contents
Advertisement
WARNING: This appliance is intended for use only with the included
Montigo burners and accessories. Never install or add any additional
or alternative media, rock wool or other material in this appliance. The
use of additional or alternative materials may pose potential safety
hazards, damage to the appliance, and void manufacturer's warranty.
Driftwood Logset Installation 46
B
A
E
D
G
K
J
M
Step 1: Log C is placed at the rear left corner of the media tray
C
Step 2: Log F is placed at the rear center of the firebox, with one end
resting on log C
Step 3: Place log B along the right side of the media tray, Log J rests
ontop of log B, forked end down
42
C
F
H
L
Do not block
the flame
carryover
hole with
logs
F
J
B
Only cover the burner with
one layer of coals. Arrange
the ember chips on top of the
burner tray. DO NOT cover the
pilot with logs.
Step 4: Log K rests on logs F and B, with the bowed end on the rear of
the box. Place log A in the middle front of the media tray.
I
Step 5: Log G in the middle of the media tray, with log D right against
it and tucked under log F.
Step 6: Rest log I with the larger end sitting in the media bed, one end
on log C. Log E is placed in the middle front of the media bed.
Step 7: Place log L along the front of the tray (front left). Log H is placed
in the rear left corner of the box. Log M is placed in the front left
M
Installation
G
D
I
E
H
L
DRSQ
46
K
A
XG0232 - 043021
Advertisement
Table of Contents
