Table of Contents
Advertisement
Propane Conversion
To convert the DelRay from Natural Gas to Propane, install the
conversion kit listed below. The unit must be disconnected from any
gas supply, disconnected from any electrical supply and batteries
and removed from any installation cavity.
PROPANE CONVERSION KIT TABLE
Units
DRSQ42NI
Kit Code
GCA026
Units
DRSQ46NI
Kit Code
GCA023
DRSQ42*I 3/16" for NG and 3/8" for Propane;
DRSQ42*I-2 3/16" for NG and 3/16 for Propane.
DRSQ46*I 3/16" for NG and 3/8" for Propane;
DRSQ46*I-2 3/16" for NG and 3/8" for Propane.
For input rating, manifold pressure and orifice size, refer to
sample rating plate
Tools required
1). Torx T20 Screw Driver Bit
2). 1/2" Socket Driver
3). 5/32" Allen Key
4). Needle Nose Pliers or
Small Flat Head Screw
Driver
5). 3/8" wrench
WARNING
This conversion kit shall be installed by a qualified gas fitter in
accordance with the manufacturer's instructions and all applicable
codes and requirements of the authority having jurisdiction. If the
information in these instructions is not followed exactly, a fire,
explosion or production of carbon monoxide may result causing
property damage, personal injury or loss of life. The qualified service
agency is responsible for the proper installation of this kit. The
installation is not proper and complete until the operation of the
converted appliance is checked as specified in the manufacturer's
instructions supplied with the kit.
34
DRSQ42NI-2
GCA027
DRSQ46NI-2
GCA024
Parts included
1). Propane burner orifice
2). Propane pilot orifice
3). Propane valve control
(with mounting screws)
4). Valve conversion label
5). Conversion plate label
6). Conversion technician
identifying label
CAUTION
The gas supply shall be shut off prior to disconnecting the electrical
power, before proceeding with the conversion.
1. Shut off gas supply.
2. Remove the 2 screws securing the pilot cover to the media tray.
Figure 13. Removal of pilot cover
3. Burner can now be removed by simply lifting up.
Figure 13.b Removing burner
4. Use 3/8" wrench to loosen off the NG gas orifice, replace with
Propane orifice as included in package.
Figure 13.c Removing the orifice
5. Using a Phillips screwdriver, loosen the screw on the primary
air adjuster. Adjust opening based on the chart show before
step 1.
Figure 13.c primary air adjuster
Installation
XG0232 - 043021
Advertisement
Table of Contents
