Installation Of The Logset; Installing The Log Set - Montigo H52-DFN Installation & Operation Manual

H52-DF Gas Fireplace
Mantels & Surrounds
NOTE: National Canadian Gas Association mantel test requirements
are for fire hazard prevention to combustible materials.
New technology, to meet consumer and government demands for the
wise use of energy, has prompted us to manufacture many models of
fireplaces which are hot, fuel and energy efficient.
Please be aware; temperatures over the mantel will rise above normal
room temperature and walls above fireplace may be hot to touch.
Drywall/
Sheetrock
Header
Non-Combustible
Facing Material
Figure 14. Combustible surrounds.
Page 12
Installation
Installing the Logs:
The H52-DFN is supplied with seven ceramic fibre logs. Unpack the logs
and handle them very carefully, install as described below.
Log Rest E
6"
Figure 16. Installation of four (4) Base Logs.
Step 1. Place the Base Logs, "A", "B", "C" & "D" as shown. Move them
left, or right to ensure they fit between the grate stiles as shown.
Figure 16a. Installation of Log E.
Step 2. Place flat portion (underside) of Log "E" on the formed steel Log
Rest as shown, lay front end of Log "E" approximately centre of
Log "B". See Figure 16 above.
Figure 16b. Installation of Log F.
Step 3. Place Log "F" in place as shown. Rest front end of Log "F" in
curved area (notch) see Figure 16a on Log "D", and rear of Log
"F" on log Grate, between back stiles.

Installing the Log Set

Log A
Log D
Log B
Log Grate
Log E
Log B
Log Grate
Log Grate
Log C
Notch
Log D
plateau
plateau
Log F
Part No. XG0650