Brick Liner Install
Before beginning any install, make sure that the unit has not been in
operation and that it is at room temperature.
Step 1: Remove the two screws on each side where the brackets will go in
Figure 20.b Remove the two screws
Step 2: Put the back panel in first, and temporarily hold it in place or
use masking tape. Don't use regular tape as it will leave residue on
the panel.
Figure 20.b hold in place or secure using masking tape
44
Step 3: Use the included clips to secure right panel into the screw hole
referenced in step 1.
Figure 20.b Secure with the bracket using screw
Step 4: Install left panel using same steps in step 3.
REAR PANEL
Figure 20.b Completed installation
Step 5: It is now safe to let the rear panel be supported by the side panels.
Installation
XG0232 - 043021