Adjusting The Projector's Elevator - ViewSonic PJ400-2 User Manual

Setting up

Adjusting the projector's elevator

WARNING ►Do not adjust the projector's elevator during use or imme-
diately after use. Handling while the projector is in a high temperature could
cause a burn and/or malfunction to the projector. Before operating, make sure
that the power switch is off, that the power cord is not plugged in, and that the
projector is cool adequately.
CAUTION ►If you press the elevator button without holding the projec-
tor, the projector might crash down, overturn, smash your fingers and possibly
result in malfunction. To prevent damaging the projector and injuring yourself,
always hold the projector whenever using the elevator buttons to adjust the
elevator feet.
►Except for inclining by the elevator feet adjustment, place the projector hori-
zontally.
You can use the elevator feet to make adjustments if the surface on which you
need to set the projector is uneven or if you otherwise need to adjust the angle of
projection. The adjustment range of the elevator feet is 0 to 9 degrees.
1.
Press and hold in the elevator buttons while holding the projector.
The elevator buttons and the elevator feet are on the both sides.
2.
Raise or lower the projector to the desired height and then release the eleva-
tor buttons.
When you release the elevator buttons, the elevator feet will lock into posi-
tion.
3.
As necessary, you can also finely adjust the height of the projector by twisting
the elevator feet by hand.
ViewSonic
Elevator feet
PJ400
Elevator button
12