About The Filter Cover For Bottom-Up Use - ViewSonic PJ400-2 User Manual

About the filter cover for bottom-up use
WARNING ►Do not replace the filter cover and/or air filter during use or
immediately after use. Handling while the projector is in a high temperature
could cause a burn and/or malfunction to the projector. Before operating, make
sure that the power switch is off, that the power cord is not plugged in, and that
the projector is cool adequately.
When the projector is installed bottom up, please use the accessory filter cover
for bottom-up use. It is higher than usual filter cover, to keep the space for intake
ventilation. Please change in the following procedure.
1.
Disconnect all the connectors and adapters that were connected to the pro-
jector's ports. Then slowly turn the projector so that the lens-side is facing up.
Please be careful for a projector not to fall. While the projector is placed lens-
side up, hold the projector.
2.
Remove the filter cover and the air filter. Hold the knobs while pulling out it.
Filter cover's knob
3.
Slowly turn the projector so that the bottom is facing up.
4.
Set a new or cleaned air filter to the filter cover for bottom-up use. Make the
claws slide along the rail, and set the air filter into place.
Claws
Rail of air filter
Filter cover for bottom-up use
5.
Interlocking the tabs, snap the filter cover for bottom-up use into place.
Tabs
Air filter's knob
Air filter (New or cleaned)
Filter cover for bottom-up use
(with an air filter)
Preparations