Quick Tool Presetter (Option) - Siemens PUMA V400/M Operation Manual

10.

QUICK TOOL PRESETTER (OPTION)

This is the device to measure the wearing of tool by means of touch sensor that contacts
directly with tool, and to change the offset of tool simply.
In general, quick tool presetter consists of touch sensor, Q-setter arm and arm position
detect proximity sensor. And according to the operation method of arm, it is classified as
follows.
- Manual type : Arm is operated by operator.
- Automatic type: Arm is operated by air, hydraulic pressure or motor.
If you operate the quick tool presetter or turret without attention, There may be interference
between turret and quick tool presetter, you can set the safety position for operation of quick
tool presetter and turret on easy extend screen.
66 | Part 2
Thus, arm cannot be upped or downed by manual operation switch or M-
code.
Thus, arm can be upped or downed by manual operation switch or M-
code.
Touch Sensor
Q-Setter Arm