Mounting To Linear Actuator; Mounting To Part-Turn Actuator; Installing Option Modules - Siemens SIPART PS2 Operating Instructions Manual

Installing/mounting
3.4 Installing option modules
3.2

Mounting to linear actuator

For linear actuators, use the "linear actuator" mounting kit 6DR4004-8V or the integrated
attachment.
You require different installation parts depending on the selected actuator type. The
mounting kit is suitable for a stroke of 3 to 35 mm. For a larger stroke range, you require a
separately ordered lever 6DR4004-8L. Refer to the detailed operating instructions for further
information on mounting.
3.3

Mounting to part-turn actuator

You require an actuator-specific VDI/VDE 3845 mount to install the positioner on a part-turn
actuator. You receive the mount and screws from the actuator manufacturer. Ensure that the
mount has a sheet metal thickness of > 4 mm and reinforcements. You also need the mounting
kit 6DR4004-8D or the stainless steel coupling TGX: 16300-1556. Refer to the detailed
operating instructions for further information on mounting.
3.4

Installing option modules

NOTICE
Improper installation of option modules
Risk of explosion in hazardous areas.
• If you upgrade the device with an option module, check the corresponding text box on the
• Before you commission the device, follow the safety-related requirements according to the
Figure 3-2
Depending on the version of the positioner, the following option modules are available:
• Digital I/O Module (DIO) 6DR4004-6A / -8A
• Analog Input Module (AIM) 6DR4004-6F / -8F
• Inductive Limit Switches (ILS) 6DR4004-6G / -8G
• Analog Output Module (AOM) 6DR4004-6J / -8J
20
type plate as in the example below.
specifications in the valid certificate and in the "Technical specifications" section.
Example
Compact Operating Instructions, 11/2022, A5E03436620-AG
SIPART PS2 (6DR5...)