Oki OKIPOS X400 Programming Manual page 93

Command Structure <ESC>CBabb
a
bb
Example: <ESC>CB+03
Placement: This command should be sent in a separate data stream.
Default:
Command Function To adjust the location of the first print line on the label.
Input to Printer
<ESC>A
<ESC>CI2<ESC>CB+03
<ESC>Z
Printer Output
There is no printer output for this command. The first print line on the next
printed label will be adjusted after the receipt of this command.
Special Notes 1.
The effects of this command are cumulative, i.e. If an <ESC>CB+06 command
is followed by an <ESC>CB-02, the resulting change in position is +4mm.
2. The maximum range for the value stored in the printer is 98 mm. Any
commands received that causes the value to exceed 00 or 98 will result in a
setting of 00 or 98 respectively.
Stop code, No other commands can be included in the data stream.
3. The value is stored in non-volatile memory and will be remained until it is
modified by another valid <ESC>CBabb command, even if power is removed
from the printer.
4. The current setting is printed out on the "Pitch Offset" line on the test label.
5. Separate offset settings are stored for gap and eye-mark sensing.
All manuals and user guides at all-guides.com
Label Tear-Off
= + to move the print line down from the top edge of the label
- to move the print line toward the top of the label.
= Distance moved in millimeters (00 to 25)
Last valid setting.
91