Original (Text/Photo); Others - Panasonic WORKIO DP-2310 Operating Instructions Manual

Basic Transmission Settings

Original (Text/Photo)

The Original setting is useful when sending photographs or illustrations with gray tones. Your machine is
preset to "TEXT". You can select either "TEXT/PHOTO" or "PHOTO" mode.

Others

2-SIDED
ORIGINAL
X-STAMP
COMPLETION
NOTICE
COMM. STATUS
GET EMAIL
FILE FORMAT
NOTE
22
TEXT
TEXT/PHOTO
PHOTO
Sending 2-Sided Original(s)
2-Sided scanning selection control is available for the user depending on the original
layout. The following selections are available for the 2-Sided scanning option:
• Long Edge : 2-Sided scanning aligned to the long edge of the original.
• Short Edge: 2-Sided scanning aligned to the short edge of the original.
Verification Stamp
• Confirms successful transmissions by stamping the bottom of each successfully
transmitted page with a small
You or a selected party can be notified with a Job Completion Notice via a pop up
screen on your/their PC when the Copy Job or the Print Job is completed. You must
setup the Job Completion Notice feature prior to starting the job and properly setup the
Status Monitor.
Confirms the commication status.
Retrieving the Email temporarily.
Chenge the send file format temporarily when sending an Internet Fax.
(DP-2310/3010 only)
1. When you select TEXT/PHOTO, or PHOTO, you machine will automatically select Fine
Resolution.
2. When you store a document in memory, the Verification Stamp will stamp on the document if it
is successfully stored in memory. In this case the Verification Stamp is not a confirmation that
the document was successfully transmitted. If you wish to disable the use of the Verification
Stamp when storing document in memory, change the setting of Fax Parameter No. 28. (See
page 193)
3. To change the preset Verification or File Format position, change the setting of Fax Parameter
No. 04 or 177. (See page192,197)
for text only originals
for text and photo originals
for photo or illustration originals
mark.