Automower ® Connect; Messages; Automower ® Intelligent Mapping (Aim); Download Firmware Over The Air Fota (Firmware Over The Air) - Husqvarna AUTOMOWER 320 NERA Operator's Manual

to stop the alarm and to start the product again. The
GeoFence is only enabled when the product is set to
ON.
®
4.8 Automower
®
Automower Connect you can enable or disable the
In
®
Automower Connect function. You can connect the
product to a Wi-Fi network. You can also see the signal
strength and connectivity status.
This menu is only available when your mobile device is
connected to the product with Bluetooth

4.9 Messages

In this menu the previous fault and information
messages can be found. For some of the messages,
there are tips and advice to help to rectify the fault.
If the product is disrupted in any way, for example it
is trapped or the battery is low, a message is saved
relating to the disruption and the time it happened.
If the same message is repeated several times, this
may indicate that an adjustment to the installation or the
product is required. Refer to
4.10 Automower
(AIM)
®
Automower Intelligent Mapping (AIM) is available in
®
the Automower Connect app. The technology uses
different sensors, GPS included, in the product. The
precision of the map is approximately 1 m / 3.3 ft.
B
A
Some of the functions with AIM are:
• It shows a map of the lawn in Automower
Connect app with charging station, boundary wire,
guide wire and islands.
24 - Settings
Connect
®
.
Installation on page 11 .
®
Intelligent Mapping
C
®
• You can make work areas (A) and (B) in the
installation where you can set a schedule and
cutting height for each work area.
• You can make stay-out zones (C) in which the
product cannot enter and cut grass.
Note:
With the AIM function you can set work areas
and stay-out zones with a precision of approximately 1
m / ft.
The data collection for the AIM map starts automatically.
The product collects data while it operates and the
map is completed in 1-2 weeks. Remove temporary
obstacles on the lawn when the product operates and
collects data. If you change the installation of the wires
or charging station, you must do a new map. Read more
about AIM in the Automower
4.11 Download firmware over the air
FOTA (Firmware over the air)
The product has a function that automatically downloads
new firmware. When a new firmware is available, a
notification shows in the app where you can select
to install the new firmware. The LED indicator of the
product pulsates when the firmware update is ongoing.
If the product does not use cellular connectivity, it
downloads new firmware when it is parked in the
charging station. The product must have Wi-Fi coverage
in the charging station to download new firmware.

4.12 Mowing profiles

You can save different sets of settings in the
profiles . Use this function when you use one product for
more than one location or to have different settings on
the same location. In the
settings, map objects and their settings are saved.
4.13 To reinstall the charging station on
the map
Reinstall the charging station on the map if you move
or replace the charging station. You can also reinstall
it if the product cannot dock or connect to the charging
station.
Map objects > Charging station in the app.
1. Select
Reinstall charging station and follow the
2. Select
instructions.
4.14 To reinstall the reference station
on the map
Reinstall the reference station on the map if you move or
replace the reference station.
Map objects > Reference station in the app.
1. Select
Reinstall reference station and follow the
2. Select
instructions.
®
Connect app.
Mowing
Mowing profiles the product
2071 - 001 - 29.03.2023