Husqvarna AUTOMOWER 320 NERA Operator's Manual page 19

a) Put the 2 ends of the boundary wire and the
end of the guide wire into the coupler.
Note:
Make sure that you can see the ends
of the wires through the transparent area of
the coupler.
b) Push down the cover on the coupler with
adjustable pliers to attach the wires in the
coupler.
9. Attach the guide wire to the ground with stakes or
bury the guide wire in the ground. Refer to
the wire into position with stakes on page 19 or
To bury the boundary wire or the guide wire on
page 19 .
10. Connect the charging station to the power outlet.
3.5.8 To put the wire into position with
stakes
CAUTION:
hold the boundary wire and the guide wire
against the ground.
CAUTION:
right after installation can damage the wire
insulation. Damage to the insulation may
not cause disruptions until several weeks or
months later.
1. Put the boundary wire and the guide wire on the
ground.
2. Put the stakes at a maximum of 75 cm / 30 in.
distance from each other.
3. Attach the stakes to the ground with a hammer or a
plastic mallet.
Note:
The wire is overgrown with grass and not visible
after a few weeks.
2071 - 001 - 29.03.2023
To put
Make sure that the stakes
Cutting the grass too low
3.5.9 To bury the boundary wire or the
guide wire
• Cut a groove in the ground with an edge cutter or a
straight shovel.
• Put the boundary wire or the guide wire 1-20 cm /
0.4-8 in. into the ground.
3.5.10 To do a visual check of the charging
station
1. Make sure that the indicator LED lamp on the
charging station has a green light.
2. If the indicator LED lamp does not have a green
light, do a check of the installation. Refer to
indicator of the charging station for boundary wire
installation on page 37 and To install the charging
station on page 17 .
LED
Installation - 19