Installation; Introduction - Installation; Main Components For Installation; To Prepare For Installation - Husqvarna AUTOMOWER 320 NERA Operator's Manual

3.1 Introduction - Installation

Read this chapter to install the product with a boundary
wire. A boundary wire is not necessary if you install the
™
product with the EPOS
™
manual for the EPOS
product.
WARNING:
safety chapter before you install the product.
CAUTION:
installation material.
Note:
Refer to www.husqvarna.com for more
information about installation.

3.2 Main components for installation

The installation involves the following components:
• A robotic lawn mower that mows the lawn
automatically.
• A charging station, which has 3 functions:
• To send control signals along the boundary
wire.
• To send control signals along the guide wire
so that the product can follow the guide wire
to specific remote areas in the garden and
can find its way back to the charging station.
• To charge the product.
• A power supply, which is connected to the
charging station and a 100-240V power outlet.
• Loop wire, which is laid around the work area
and around objects and plants that the product
must not run into. The loop wire is used both as
boundary wire and guide wire.

3.3 To prepare for installation

Read the installation chapter before you start the
installation. Prepare the installation carefully to make the
product operate satisfactorily.
• Make a blueprint of the work area and include all
obstacles. This makes it easier to examine where
to put the charging station, the boundary wire and
the guide wire.
• Make a mark on the blueprint where to put the
charging station, the boundary wire and the guide
wire.
2071 - 001 - 29.03.2023
Plug-in Kit, read the operator's
Plug-in Kit to install it with the
Read and understand the
Use original spare parts and

3 Installation

• Make a mark on the blueprint where the guide wire
connects to the boundary wire. Refer to
the guide wire on page 18 .
• Fill in holes in the lawn to make it level.
• For Automower
you have Wi-Fi coverage in the charging station
to download new firmware. Refer to
firmware over the air FOTA (Firmware over the air)
on page 24 . For Automower
this is recommended, but not necessary.
• For Automower
you have Wi-Fi coverage in the work area if
you use the Automower
Refer to
16 . For Automower
recommended, but not necessary.
Note:
coverage in the work area. If you have Wi-Fi
coverage, you can control and make settings
for the product remotely with the Automower
Connect app. The product automatically connects
to Wi-Fi when it is in an area that has Wi-Fi
coverage.
• Cut the grass before you install the product. Make
sure that the grass is maximum 10 cm / 3.9 in.
Note:
The first weeks after installation the sound level
when the product cuts the grass can be higher than
usual. The sound level decreases after some time.

3.4 Before the installation of the wires

You can select to attach the wires with stakes or bury
them. You can use the 2 procedures for the same work
area.
3.4.1 To examine where to put the charging
station
• Keep a minimum 3 m / 10 ft. of free space in front
of the charging station. Refer to
to put the guide wire on page 15 .
CAUTION:
Holes with water in
the lawn can cause damage to the
product.
®
320 NERA, make sure that
®
®
320 NERA, make sure that
®
Connect app remotely.
Automower ® Connect app on page
®
430X/450X NERA this is
We recommend you to have Wi-Fi
CAUTION:
If you use a dethatcher
in the work area, bury the boundary wire
and the guide wire to prevent them from
damage.
To install
Download
430X/450X NERA
®
To examine where
Installation - 11